crwdns2933423:0crwdne2933423:0

Prerrequisito del procedimiento de apertura del Motorola Moto X4

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:06crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:01crwdne2931653:0
Motorola Moto X4 Opening Procedure Prerequisite, Heat the screen: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Motorola Moto X4 Opening Procedure Prerequisite, Heat the screen: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Heat the screen
  • Before you begin, turn off your phone.

  • Heat an iOpener and apply it to the left edge of the phone for two minutes.

  • You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage.

  • As you wait, take note of the the following areas:

  • Display cable—be careful not to slice too deeply near the edge here, or you may damage the display cable.

  • Fingerprint sensor cable—be careful not to slice too deeply near the edge here, or you may damage the fingerprint sensor cable.

Antes de empezar, apaga tu teléfono.

Calienta un iOpener y aplícalo en el borde izquierdo del teléfono durante dos minutos.

Puede que tengas que recalentar y volver a aplicar el iOpener varias veces para que el teléfono se caliente lo suficiente. Sigue las instrucciones del iOpener para evitar el sobrecalentamiento.

También puedes usar un secador de pelo, una pistola de aire caliente o una plancha, pero ten cuidado de no sobrecalentar el teléfono: tanto la pantalla como la batería interna pueden dañarse por el calor.

Mientras esperas, fíjate en las siguientes zonas:

Cable de la pantalla: ten cuidado de no cortar demasiado cerca del borde, o podrías dañar el cable de la pantalla.

Cable del sensor de huellas dactilares: ten cuidado de no cortar demasiado cerca del borde, o podrías dañar el cable del sensor de huellas dactilares.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0