crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

iPhone 11 Pro 耳机扬声器和前传感器组件更换

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:06crwdne2931653:0
iPhone 11 Pro Earpiece Speaker and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 iPhone 11 Pro Earpiece Speaker and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 iPhone 11 Pro Earpiece Speaker and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • If you successfully removed the entire ambient light sensor, as shown in the first photo, continue to the next step below.

  • If the white diffuser strip detached and remains embedded in the display, as shown in the second photo, you will need to carefully lever it out along the top edge using a thin blade or pry tool. Re-applying heat first may make this task a bit easier.

  • During reassembly, install the diffuser into the display first, making sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third).

  • Then, set the ambient light sensor on top of the diffuser. You will need to hold the sensor in position while installing the screws securing the earpiece/sensor assembly. Once the screws are tightened, the sensor will stay in place and work normally.

如果你成功移除了整个环境光传感器，如第一张照片所示，请继续执行下面的下一步。

如果白色扩散板条脱落并仍然嵌入显示屏中，如第二张照片所示，你将需要使用薄刀片或撬动工具小心地将其沿着顶部边缘撬开。

首先重新施加热量可能会使此任务容易一些。在重新组装过程中，请先将扩散器安装到显示器上，并确保其朝向正确的方向（第一幅图像显示为正面，而第三幅图像显示为背面）。

然后，将环境光传感器放在漫射器顶部。在安装固定听筒/传感器组件的螺钉时，你需要将传感器固定在适当的位置。拧紧螺丝后，传感器将保持在原位并正常工作。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0