crwdns2933423:0crwdne2933423:0

iPhone11 Pro イヤピーススピーカーとフロントセンサアセンブリの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:06crwdne2931653:0
iPhone 11 Pro Earpiece Speaker and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 iPhone 11 Pro Earpiece Speaker and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 iPhone 11 Pro Earpiece Speaker and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • If you successfully removed the entire ambient light sensor, as shown in the first photo, continue to the next step below.

  • If the white diffuser strip detached and remains embedded in the display, as shown in the second photo, you will need to carefully lever it out along the top edge using a thin blade or pry tool. Re-applying heat first may make this task a bit easier.

  • During reassembly, install the diffuser into the display first, making sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third).

  • Then, set the ambient light sensor on top of the diffuser. You will need to hold the sensor in position while installing the screws securing the earpiece/sensor assembly. Once the screws are tightened, the sensor will stay in place and work normally.

最初の写真に示すように、環境光センサー全体を正常に取り外した場合は、次の手順に進みます。

白いデュフューザー用ストリップが外れていて、ディスプレイに挟まったままの場合(画像2参照)、薄いブレードもしくはこじ開けるツールを使って、上部端に沿って慎重に取り出してください。作業の前に熱を当てて温めると、より簡単に進みます。

再組み立ての際は、まず最初にディスプレイ中にデュフューザーを正しい方向に取り付けているか確認しながら、インストールしてください。(正面側は1番目の画像で確認できます。背面側は3番目の画像を参照してください。)

それから、環境光センサーをディフューザーの上に搭載します。手でセンサーを固定しながら、ネジでイヤピース/センサーアセンブリを取り付けてください。ネジが締まったら、センサーは固定されて通常通り稼働します。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0