Hover-1 Charger Gyroscope Sensor Board Replacement

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:03crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:03crwdne2931653:0

Hover-1 Charger Gyroscope Sensor Board Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Hover-1 Charger Gyroscope Sensor Board Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Hover-1 Charger Gyroscope Sensor Board Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Push the rubber sheaths away from the clasp of the green bullet connector.
Grasp the connector at the metal junction and disconnect.
Repeat for the yellow and red bullet connectors.
There may be a zip tie holding these wires together. Cut this off.
These bullet connectors may be hard to disconnect; do not be afraid to pull with strong force.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0