crwdns2933423:0crwdne2933423:0

Motorola Moto G6 リアガラスパネルの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:09crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
Motorola Moto G6 Rear Glass Replacement, Remove the Rear Glass: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Remove the Rear Glass
  • Power your phone off before you begin.

  • If possible, drain the battery before disassembly. When the battery is charged, there's an increased risk of a dangerous thermal event if the battery is overheated or damaged during repairs.

  • If the rear glass is cracked, completely cover it with packing tape to contain the glass shards and avoid injury.

  • Prepare an iOpener and heat the back of the phone along its bottom edge for about two minutes, or until it's slightly too hot to touch. This will help soften the adhesive securing the rear glass.

  • You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage.

作業を始める前に、電源を切ってください。

できれば解体前に、バッテリーを放電してください。バッテリーが充電されていると、バッテリーがオーバーヒートしたり、作業中に誤ってダメージを与えてしまうと危険な発火事故を起こすリスクが高まります。

リアガラスに亀裂が入っている場合は、梱包用テープで表面を覆ってください。ガラスが飛散することによる怪我を防ぐためです。

iOpenerを準備して、デバイス端に沿って約2分間温めます。熱くて触れない程度まで温まると、リアガラスを固定している接着剤が柔らかくなっています。

接着剤を十分に柔らかくするには、iOpenerを複数回に渡って温めて、作業を繰り返す必要があります。オーバーヒートを防ぐため、iOpenerの使用方法を参照してください。

ヘアードライヤー、ヒートガンやホットプレートでも対応できますが、デバイスのオーバーヒートにはご注意ください。ディスプレイと内蔵バッテリーは、ヒートダメージを受けやすいです。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0