Makita Jack Hammer HM1307CB Rear Cover Replacement

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936323:0crwdne2936323:0

crwdns2931653:01crwdne2931653:0

Remove six hex screws

Remove the six 5 mm hex screws holding the rear cover in place.
These six hex screws are all held in place with threadlocker, and may take quite a bit of torque or even some heat to loosen.
During reassembly, clean the residual threadlocker from these screws, then reapply high-strength (red) threadlocker to each one before reinstalling.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0