Makita Jack Hammer HM1307CB Controller Replacement

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936319:0crwdne2936319:0

crwdns2931653:01crwdne2931653:0

Remove four screws from the controller cover

Remove the following screws:
Two Phillips
Two 3 mm hex
These two hex screws are held in place with threadlocker and may require quite a bit of torque to remove.
During reassembly, clean the residual threadlocker from these screws, then reapply high-strength (red) threadlocker to each one before reinstalling.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0