crwdns2933423:0crwdne2933423:0

GI Node with Pressure Transducer Assembly

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:013crwdne2931653:0
GI Node with Pressure Transducer Assembly, Stripping Pressure Transducer Wires Cont.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 GI Node with Pressure Transducer Assembly, Stripping Pressure Transducer Wires Cont.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Stripping Pressure Transducer Wires Cont.
  • Continue stripping off an inch or so at a time until you have stripped off 6-8 inches of black shielding.

  • Use wire cutters to cut the blue wire and plastic strips with every piece of black shielding that's removed (will make it easier to remove shielding as you go on).

  • Cut about 3-4'' off of the red sensor wire before stripping. This will allow all wires to be aligned once voltage regulator and additional wires are soldered on (Step 20).

  • Use wire strippers to strip off about 1/4 inch off of the black and red wires.

  • The stripped wire should now look like this.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0