crwdns2933423:0crwdne2933423:0

Melitta Caffeo Solo Heater Replacement

crwdns2933809:0crwdne2933809:0

crwdns2935433:0crwdne2935433:0

Open the Melitta Caffeo Solo

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0

      The photo shows the old and the new heater next to each other. Mostly you have to transfer add-on parts (cable sleeve, screws, and clamping plates) from the old part to the new part.

      crwdns2936071:02crwdne2936071:0

      Unscrew three Torx T20 screws.

      crwdns2936071:03crwdne2936071:0

      Loosen the retaining screw of the instantaneous water heater with a 4 mm Allen key.

      crwdns2936071:04crwdne2936071:0

      Pull out the clips on the two pressure hoses and remove the two connections.

      crwdns2936071:05crwdne2936071:0

      Now the thermoblock is only attached to the thermosensor. Unscrew it with an open-end wrench SW8. Make sure that the fragile cables are not twisted and torn off.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0