crwdns2933423:0crwdne2933423:0

Jura model Z Replace water heater

crwdns2933809:0crwdne2933809:0

crwdns2935433:0crwdne2935433:0

Opening the Jura Z series housing

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0

      Here is one of the two water heaters removed.

      crwdns2936071:02crwdne2936071:0

      Loosen the Torx T15 screw on the lid over the instant hot water heater.

      crwdns2936071:03crwdne2936071:0

      The support of the instant water heater is fastened with a single, slightly recessed screw. Unscrew this Torx T15 screw.

      crwdns2936071:04crwdne2936071:0

      The two water heaters are fixed in the middle with a Torx T25 screw (marked in red). The locknut on the back is loose in the carrier and often falls out while turning the screw.

      crwdns2936071:05crwdne2936071:0

      Remove the cable shoes from the water heater connections.

      crwdns2936071:06crwdne2936071:0

      Now only the hoses are connected. They are attached with clips.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0