Kenwood Chef Drive Gear replace

crwdns2936071:01crwdne2936071:0 — Tools

Prepare your Tools.

crwdns2936071:02crwdne2936071:0 — Open Electronic box

Remove five Screens T20 from the bottom and lift the bottom plate up.

crwdns2936071:03crwdne2936071:0 — Remove electronic box

Separate nine cables.

crwdns2936071:04crwdne2936071:0 — Loosen the tilt mechanics

Tilt the machine head.

crwdns2936071:05crwdne2936071:0 — Spring and design plate

Pull the spring out.

crwdns2936071:06crwdne2936071:0 — Remove cover

Remove four screws T20.

crwdns2936071:07crwdne2936071:0 — Remove top cover

Remove two screws T20.

crwdns2936071:08crwdne2936071:0 — Remove motor cover

Remove three screws T20 and the washers.

crwdns2936071:09crwdne2936071:0 — Motor

Remove three screws T20 and the plastic washers.

crwdns2936071:010crwdne2936071:0 — Remove drive gear

Using a punch and a hammer push out the pin. (Note: support the gear on the opposite side to protect the the motor shaft from damage).