Removing and replacing the grinder

crwdns2936071:01crwdne2936071:0

Remove the lock washer on the axle for grinding degree adjustment using pliers.

crwdns2936071:02crwdne2936071:0

Remove the grinding degree adjustment axle by using pliers to pull it upwards.

crwdns2936071:03crwdne2936071:0

Remove the 2 screws on the bean container of the coffee machine with the Torx T10 screwdriver.

crwdns2936071:04crwdne2936071:0

Remove the bean container.

crwdns2936071:05crwdne2936071:0

Remove the pinion for the grinding degree adjustment.

crwdns2936071:06crwdne2936071:0

Remove the 3 screws attaching the grinding mill attachment to the grinder with the Torx T10 screwdriver.

crwdns2936071:07crwdne2936071:0

Make sure not to rip any cables in this step.

crwdns2936071:08crwdne2936071:0

Disconnect the first connector (black cable) from the plug-in connector attached to the bottom of the grinder.

crwdns2936071:09crwdne2936071:0

Separate the second (white) cable attached to the grinder from the housing of the plug-in connector.

crwdns2936071:010crwdne2936071:0

Remove the grinder to clean or replace it.

crwdns2936071:011crwdne2936071:0

Avoid putting the grinder down completely in this step, but hold it in your hand.

crwdns2936071:012crwdne2936071:0

Now set the grinder back into its correct position

crwdns2936071:013crwdne2936071:0

Reattach the 3 screws for grinding mill by fastening them to the inserted grinder with the Torx T10 screwdriver.

crwdns2936071:014crwdne2936071:0

Reinsert the pinion.

crwdns2936071:015crwdne2936071:0

Reinsert the bean container into the coffee machine.

crwdns2936071:016crwdne2936071:0

Fasten the two screws we remove from the bean container earlier with the Torx T10 screwdriver.

crwdns2936071:017crwdne2936071:0

Reinsert the axle for grinding degree adjustment.

crwdns2936071:018crwdne2936071:0

Use pliers to reseat the safety washer.