crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Autosampler Node Troubleshooting (For New & Old Versions)

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:010crwdne2931653:0
Autosampler Node Troubleshooting (For New & Old Versions), Trigger autosampler with node battery.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Autosampler Node Troubleshooting (For New & Old Versions), Trigger autosampler with node battery.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Trigger autosampler with node battery.

  • Click here to watch a video of how to trigger the autosampler with the node battery.

  • Disconnect the relay board from the Open-Storm board.

  • Connect a red, black, and white jumper wire into the pluggable header (that was attached the board).

  • Connect a XX resistor in the same holes as the black and white wires. Resistors are blind to the polarity in a circuit. So you don't have to worry about installing them backwards.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0