如何更换三星 Galaxy S 系列手机客制化胶带

crwdns2935425:02crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:02crwdne2931653:0

Fingerprint sensor and gasket adhesive

The following three steps show how to remove and transfer the fingerprint sensor and its gasket.
If your phone's fingerprint sensor and camera reside on a single rear bezel (like on the S9), you can transfer that bezel without removing the parts individually.
Heat an iOpener and apply it to the fingerprint sensor for one minute.
Use an opening tool to gently pry the fingerprint sensor at the lower seam, where it contacts the back cover.
Do not pry at the upper seam, which is the fingerprint gasket seam.

指纹传感器和垫圈

以下三个步骤显示了如何卸下和转移指纹传感器及其垫圈。
如果手机的指纹传感器和摄像头位于单个后挡板（如S9上），则可以转移该挡板，而无需单独卸下部件。
加热 iOpener 并将其应用于指纹传感器一分钟。
使用打开工具在与后盖接触的下部接缝处轻轻撬动指纹传感器。
请勿撬起指纹密封垫接缝的上接缝。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0