crwdns2933423:0crwdne2933423:0

Cómo reemplazar el adhesivo cortado a medida para Móviles Samsung Galaxy S

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:02crwdne2931653:0
How To Replace Custom-cut Adhesive For Samsung Phones, Fingerprint sensor and gasket adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 How To Replace Custom-cut Adhesive For Samsung Phones, Fingerprint sensor and gasket adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 How To Replace Custom-cut Adhesive For Samsung Phones, Fingerprint sensor and gasket adhesive: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Fingerprint sensor and gasket adhesive
  • The following three steps show how to remove and transfer the fingerprint sensor and its gasket.

  • If your phone's fingerprint sensor and camera reside on a single rear bezel (like on the S9), you can transfer that bezel without removing the parts individually.

  • Heat an iOpener and apply it to the fingerprint sensor for one minute.

  • Use an opening tool to gently pry the fingerprint sensor at the lower seam, where it contacts the back cover.

  • Do not pry at the upper seam, which is the fingerprint gasket seam.

Los tres pasos siguientes muestran cómo retirar y transferir el sensor de huellas digitales y junta.

Si el sensor de huellas digitales y la cámara de su teléfono se encuentran en un único bisel trasero (como en el S9), puedes transferir ese bisel sin necesidad de retirar las piezas individualmente.

Calienta un iOpener y aplícalo al sensor de huellas digitales durante un minuto.

Utiliza una herramienta de apertura para hacer palanca suavemente el sensor de huellas digitales en el borde inferior, donde entra en contacto con la tapa trasera.

No hagas palanca en el borde superior, que es la unión de la junta de la huella digital.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0