crwdns2933423:0crwdne2933423:0

Open a Saeco Minuto

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0

      Disconnect the power plug!

      crwdns2936071:02crwdne2936071:0

      Pry up with a plastic opening tool at the bottom edge of the chrome-plated cover to lift up the coffee dispensing spout. This cover is often very tight, so you have to pry hard and hope that the part does not break.

      crwdns2936071:03crwdne2936071:0

      Remove the Torx T10 screw at the top edge of the coffee dispensing spout.

      crwdns2936071:04crwdne2936071:0

      Lift off the black cover over the coffee dispensing spout. The sliding nozzles will come off at the same time.

      crwdns2936071:05crwdne2936071:0

      Remove both Torx T10 screws on the left and right at the bottom edge of the coffee dispensing spout.

      crwdns2936071:06crwdne2936071:0

      Remove the Torx T20 screw on the finger guard of the grinder. Remove the finger guard.

      crwdns2936071:07crwdne2936071:0

      Remove the three Torx T10 screws under the water tank.

      crwdns2936071:08crwdne2936071:0

      Grab the upper cover on the sides and lift it up.

      crwdns2936071:09crwdne2936071:0

      Remove the water level sensor cable from its brackets.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0