crwdns2933423:0crwdne2933423:0

MacBook Pro 15" Touch Bar 2018 Logic Board Einheit austauschen

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935425:028crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:028crwdne2931653:0
MacBook Pro 15" Touch Bar 2018 Logic Board Assembly Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 MacBook Pro 15" Touch Bar 2018 Logic Board Assembly Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 MacBook Pro 15" Touch Bar 2018 Logic Board Assembly Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • When reinstalling the logic board assembly:

  • Check the alignment of the rubber vibration dampers, and adjust them as needed.

  • Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

  • Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

Beim Wiederzusammenbau gehst du folgendermaßen vor:

Stelle sicher, dass die Schwingungsdämpfer aus Gummi richtig ausgerichtet sind.

Führe den Antennenkabelstrang durch die Lücke zwischen dem Logic Board und dem Kühlkörper und stelle sicher, dass er richtig ausgerichtet ist, wenn du das Logic Board absenkst.

Vergewissere dich, dass beim Einsetzen keine Kabel unter dem Board eingeklemmt werden. Überprüfe jede markierte Stelle sorgfältig.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0