crwdns2933423:0crwdne2933423:0

2018年带 Touch Bar 的15寸 MacBook Pro 底壳更换

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:011crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:01crwdne2931653:0
MacBook Pro 15" Touch Bar 2018 Lower Case Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 MacBook Pro 15" Touch Bar 2018 Lower Case Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Completely power off and unplug your MacBook Pro before you start. Close the display and flip the entire laptop upside-down.

  • Use a P5 Pentalobe driver to remove six screws securing the lower case, of the following lengths:

  • Four 4.7 mm screws

  • Two 6.6 mm screws

  • Note how the screws come out at a slight angle—you must reinstall them the same way.

  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.

开始之前,请完全关闭并拔下 MacBook Pro的电源插头。

关闭显示屏并翻转整个笔记本电脑。使用P5 五角螺丝刀卸下固定底壳的六个螺丝,长度如下:

四颗 4.7 mm 螺丝

两颗 6.6 mm 螺丝

在拆卸螺钉时请注意螺丝的方向 —— 需要以微小的角度重新安装。

在整个维修过程中,记录每个螺丝并确保它准确地回到原来的位置以避免损坏你的设备。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0