crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Samsung Galaxy S10e Vervanging van de achterste behuizing

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:010crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0

crwdns2935425:014crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:014crwdne2931653:0
Samsung Galaxy S10e Back Cover Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

  • Follow this guide to reinstall the back cover and replace the adhesive.

  • Be sure to turn on your phone and test your repair before installing new adhesive and resealing the phone.

  • If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the leftover adhesive is usually more than strong enough to hold.

Volg deze handleiding om de achterste behuizing weer op je telefoon te zetten en de lijm eronder te vervangen.

Zorg dat je je telefoon aanzet en deze test voordat je deze weer helemaal in elkaar zet en sluit.

Als je wilt, kun je de achterste behuizing terug zetten zonder vervangende lijm. Verwijder dan eerst alle lijmresten die voorkomen dat de achterkant goed past. Na het installeren van de achterkant verwarm je het en zet je er druk op om deze te laten hechten. Het zal niet waterdicht zijn, maar de lijm is sterk genoeg om de achterkant te bevestigen.

[* icon_reminder] [guide|124003|Follow this guide|new_window=true] to reinstall the back cover and replace the adhesive.
[* icon_note] Be sure to turn on your phone and test your repair before installing new adhesive and resealing the phone.
-[* icon_note] If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.
+[* icon_note] If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. ***It won't be waterproof***, but the leftover adhesive is usually more than strong enough to hold.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0