DeWalt DCS380 Motor Armature Replacement

crwdns2935421:0crwdne2935421:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:02crwdne2931653:0

DeWalt DCS380 Motor Armature Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0

DeWalt DCS380 Motor Armature Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

Remove two M8x12mm T20 bolts from the bearing retainer.
Pull the shaft out of the gearbox.
Please note, the brushes will need to be disengaged to reassemble the motor. See the end of the Motor Brush replacement section of this guide for details.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0