crwdns2933423:0crwdne2933423:0

Istruzioni iOpener

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:01crwdne2931653:0
iOpener Instructions: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 iOpener Instructions: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 iOpener Instructions: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Lay the iOpener clear-side down, flat on the edge of the device, over an adhesive seal you wish to heat. The liquid will flatten the iOpener against the surface, ensuring good heat conduction.

  • Let the bag sit on the device for approximately 90 seconds before attempting to open the front panel.

  • At this point you should be able to begin prying under the screen with a plastic opening tool. Be sure to see your device's specific guide for where and how to do this.

  • During the procedure you may need to reheat the iOpener. To prevent overheating the iOpener, always wait until the iOpener has cooled enough to touch safely. Do not microwave the iOpener for more than thirty seconds at a time.

Appoggia l'iOpener, con il lato lucido rivolto verso il basso, sul bordo piatto del dispositivo, sopra una guarnizione adesiva che vuoi riscaldare. Il liquido appiattirà l'iOpener contro la superficie, assicurando una buona conduzione del calore.

Lascia riposare sul dispositivo per circa 90 secondi prima di tentare di aprire il pannello anteriore.

A questo punto dovresti essere in grado di iniziare a far leva sotto lo schermo con uno strumento di apertura in plastica. Consulta la guida specifica per il tuo dispositivo per sapere dove e come farlo.

Durante la procedura potrebbe essere necessario scaldare più volte l'iOpener. Per evitare di surriscaldarlo, attendi sempre che si sia raffreddato abbastanza da poterlo toccare in sicurezza. Non riscaldare l'iOpener per più di trenta secondi alla volta.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0