crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

iPhone XR 耳机扬声器和前传感器组件更换

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:08crwdne2931653:0
iPhone XR Earpiece and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 iPhone XR Earpiece and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 iPhone XR Earpiece and Front Sensor Assembly Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • If you successfully removed the entire ambient light sensor, as shown in the first photo, continue to the next step below.

  • If the white diffuser strip is detached and remains embedded in the display, as shown in the second photo, you will need to carefully lever it out along the top edge using a thin blade or pry tool. Re-applying heat first may make this task a bit easier.

  • During reassembly, install the diffuser into the display first, making sure it faces the right direction (the front-facing side is shown in the first image, and the rear-facing side is shown in the third).

  • Then, set the ambient light sensor on top of the diffuser. You will need to hold the sensor in position while installing the screws securing the earpiece/sensor assembly. Once the screws are tightened, the sensor will stay in place and work normally.

如果你成功移除了整个环境光线传感器，如第一张照片所示，请继续执行下一步骤。

如果白色漫射条脱落并嵌入显示屏中，如第二张照片所示，则需要使用薄刀片或撬具工具沿顶部边缘小心地将其拉出。首先重新加热可以使这项任务更容易一些。

在重组过程中，首先将漫射器安装到显示器中，确保它朝向正确的方向（前面一侧显示在第一张图片中，后面一面显示在第三张图片中）。

然后，将环境光传感器设置在漫射器顶部。在安装固定耳机/传感器组件的螺丝时，你需要将传感器固定到位。拧紧螺丝后，传感器将保持原位并正常工作。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0