crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0
crwdns2935425:01crwdne2935425:0
crwdns2931653:01crwdne2931653:0
-
Use a T6 Torx driver to remove the four 7.2 mm screws securing the fan:
-
Two screws securing the fan to the logic board
-
Two screws with rubber shoulders securing the fan to the exhaust vent
| [* black] Use a T6 Torx driver to remove the four 7.2 mm screws securing the fan: | |
| [* red] Two screws securing the fan to the logic board | |
| - | [* orange] Two screws securing the fan to the exhaust vent |
| + | [* orange] Two screws with rubber shoulders securing the fan to the exhaust vent |
| [* icon_note] Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened. |
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0