crwdns2933423:0crwdne2933423:0

iPhone 6s スピーカーの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:06crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
iPhone 6s Speaker Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iPhone 6s Speaker Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Use the point of a spudger to lift and disconnect the antenna cable from the bottom end of the logic board.

  • To reconnect antenna cables like these to the socket, carefully align the connector to the socket, then use the flat end of a spudger to press down. It should click in place. If not, check for alignment. Do not use excessive force.

スパッジャーの先端を使って、ロジックボード先端の下側からアンテナケーブルを引き上げて、接続を外します。

アンテナケーブルをソケットに再接続するには、慎重にコネクタとソケットの位置合わせしてから、スパッジャーの平面側の先端を押し下げます。 カチッと装着音がするはずです。音が聞こえない場合は、位置合わせを確認してください。 過度の力を加えないでください。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0