crwdns2933423:0crwdne2933423:0

iPod Touch 2. Generation Akku tauschen

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:07crwdne2931653:0
iPod Touch 2nd Generation Battery Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iPod Touch 2nd Generation Battery Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Place your battery in the rear panel, with the cable side down, and use two small strips of electrical tape to hold the cable against the solder pads.

  • Installing the battery upside down (with the cable facing up) will destroy the logic board.

  • Place a strip of tape over the end of the battery ribbon cable to both cover two of the solder pads and hold the contacts down against the logic board.

  • Heat the rightmost contact until the solder below melts and apply a small amount of solder to the contact, allowing it to flow through the two holes in the cable and down to the logic board.

  • Do not apply too much solder. The amount required for a proper bond is miniscule.

  • As soon as the solder has flowed into the joint, remove both the solder and the iron.

Lege den neuen Akku mit der Kabelseite nach unten in die Gehäuserückseite. Klebe das Kabel mit zwei kleinen Stücken von Isolierband gegen die Lötstellen.

Wenn du den Akku mit der Kabelseite nach oben einbaust, wird das Logic Board zerstört.

Befestige einen Streifen des Isolierbands so über das Ende des Akku-Flachbandkabels, dass zwei der Lötstellen abgedeckt sind und der Kontakt zum Logic Board hergestellt ist.

Erhitze die ganz rechts liegende Lötstelle, bis das Lötzinn darunter schmilzt und gib noch etwas Lötzinn dazu, so dass es durch die beiden Löcher im Kabel bis zum Logic Board fließt.

Gib nicht zu viel Lötzinn dran, ein winziger Tropfen genügt.

Wenn die Verbindung hergestellt ist, entferne das Lötzinn und die Lötspitze.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0