crwdns2933423:0crwdne2933423:0

iPod Touch 2. Generation Akku tauschen

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:04crwdne2931653:0
iPod Touch 2nd Generation Battery Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 iPod Touch 2nd Generation Battery Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 iPod Touch 2nd Generation Battery Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • The battery on the second generation Touch is attached via solder pads with small holes that go through the battery ribbon cable and attach to flat pads on the face of the logic board. In this step, you will heat each solder pad individually while using a metal spudger to pry it up from the logic board.

  • DO NOT bridge the connection between the solder pads both on the board and on the ribbon cable with your spudger. Shorts have the potential to ruin the logic board.

  • Beware of overheating the board and the cable. Only hold the tip of the iron against the pad long enough to let the solder melt. Excess heat buildup has the potential to ruin the logic board or melt the ribbon cable.

  • Start working from one side of the battery ribbon cable. In our case, we started on the left. Heat the leftmost solder pad while gently prying up from under the ribbon cable to free it from the board. Repeat this process for each of the two remaining pads, working either right to left or left to right.

Beim iPod Touch der 2. Generation ist der Akku mit Lötstellen in Löchern durch das Akku -Flachbandkabel angeschlossen. Diese Lötstellen haben Kontakt zur Oberfläche des Logic Boards. Bei diesem Schritt werden die Lötverbindungen einzeln erhitzt und mit einem Metallspatel vom Logic Board gelöst.

Achte darauf, dass du dabei mit dem Metallspatel keinen Kurzschluss zwischen den Lötstellen herstellst. Dadurch könnte das Logic Board kaputt gehen.

Überhitze weder das Logic Board noch das Kabel. Halte die Lötspitze nur so lange an die Lötstelle, bis das Lötzinn geschmolzen ist. Durch zu viel Hitze kann das Logic Board und das Kabel kaputt gehen.

Beginne an einer Seite des Akku -Flachbandkabels. Hier wurde an der linken Seite begonnen. Erhitze die Lötstelle und heble behutsam unter dem Flachbandkabel, bis es sich von der Platine löst. Wiederhole für die anderen beiden Lötstellen, von links nach rechts (oder von rechts nach links).

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0