crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

更换任天堂Switch背部外壳

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:022crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:04crwdne2931653:0
Nintendo Switch Rear Panel Replacement, Remove the top and bottom screws: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Nintendo Switch Rear Panel Replacement, Remove the top and bottom screws: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Remove the top and bottom screws

  • Use a JIS 00 driver to remove the following screws securing the rear panel:

  • One 2.5 mm-long screw on the top edge of the device

  • Two 2.5 mm-long screws on the bottom edge of the device

  • To prevent these tight screws from stripping, apply firm downward force, work slowly and try another JIS 00 driver if the screws won't come out. Make sure the driver is fully inserted.

  • You can use a Phillips #000 screwdriver in a pinch, but you risk damaging or stripping the screws. Push down firmly on the screwdriver and twist slowly. Often, switching drivers may help, even if they are the same size.

移除顶部和底部螺丝

使用 JIS 00 螺丝刀，或者 iFixIt PH 00 螺丝刀取下用于固定后面板的螺丝：

一颗在主机顶部的散热器出口旁，长度为2.5毫米的螺丝

两颗在主机底部的充电接口两侧，长度为2.5毫米的螺丝

面板上的这些螺丝比较容易滑丝，为了防止滑丝发生，在拆卸过程中请用力向螺丝施加压力，同时缓慢拧动螺丝刀，如果螺丝无法拧出来，尝试换另一个JIS 000 或 PH 000 螺丝刀试一下。

临时应急时，您可以使用Phillips 螺丝刀，但有损坏或拧花螺丝的风险。请用力下压螺丝刀并缓慢旋转。通常，更换螺丝刀（即使型号相同）可能会有所帮助。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0