crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Reemplazo de panel trasero de Nintendo Switch

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:022crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:04crwdne2931653:0
Nintendo Switch Rear Panel Replacement, Remove the top and bottom screws: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Nintendo Switch Rear Panel Replacement, Remove the top and bottom screws: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Remove the top and bottom screws

  • Use a JIS 00 driver to remove the following screws securing the rear panel:

  • One 2.5 mm-long screw on the top edge of the device

  • Two 2.5 mm-long screws on the bottom edge of the device

  • To prevent these tight screws from stripping, apply firm downward force, work slowly and try another JIS 00 driver if the screws won't come out. Make sure the driver is fully inserted.

  • You can use a Phillips #000 screwdriver in a pinch, but you risk damaging or stripping the screws. Push down firmly on the screwdriver and twist slowly. Often, switching drivers may help, even if they are the same size.

Retira los tornillos superiores e inferiores

Usa un destornillador JIS 00 para quitar los siguientes tornillos que fijan el panel trasero:

Un tornillo de 2.5 mm de longitud en el borde superior del aparato.

Dos tornillos de 2.5 mm de longitud en el borde inferior del aparato

Para prevenir estos tornillos duros de barrerse, aplica presión firme hacia abajo, ve despacio y trata de usar un destornillador JIS 000 o PH 000 si los tornillos no salen. Asegúrate de que el destornillador esté completamente insertado.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0