Disassembling Black and Decker BL3000S Blender Base

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:04crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:04crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936323:0crwdne2936323:0

crwdns2931653:04crwdne2931653:0

Disassembling Black and Decker BL3000S Blender Base: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

Remove the following screws that secure the top and bottom halves of the base.
One 1/4 Phillips screw
One TA-20 screw
Both screwdrivers must have a minimum of a three inch shank (length).
Screwdrivers with extenders will not fit down the access holes.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0