crwdns2933423:0crwdne2933423:0

Sostituzione del braccio e del cavo del stabilizzatore della fotocamera del DJI Phantom 3 Pro

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:02crwdne2931653:0
DJI Phantom 3 Pro Camera Gimbal Arm and Cable Replacement, Disassembling the camera control case (1): crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 DJI Phantom 3 Pro Camera Gimbal Arm and Cable Replacement, Disassembling the camera control case (1): crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Disassembling the camera control case (1)
  • Remove the (4) Phillips 0 screws from the bottom of the case as pictured. Keep seperated as the 2 (Orange) in the plastic cover are shorter. Remove the plastic cover by sliding it out.

  • Slide a metal spudger between the ribbon cable and control body where pictured to release the adhesive.

  • Gently rock the upper case side to side while pulling the upper half straight from the lower half. Work the upper case free from the bearing and shaft. Watch that the cable doesn't re-attach itself. The bearing may stay in the upper case or on the shaft. If it's on the shaft, then remove it and set aside.

Rimuovi le (4) viti Phillips 0 dal fondo della custodia come illustrato. Tieni separate le 2 viti (arancioni) nella copertura di plastica, poiché sono più corte. Rimuovi la copertura di plastica facendola scorrere fuori.

Fai scivolare uno spudger metallico tra il cavo a nastro e il corpo di controllo dove indicato per staccare l'adesivo.

Dondola delicatamente il lato della parte superiore da un lato all'altro mentre tiri la metà superiore dritta dalla metà inferiore. Sblocca la parte superiore dalla boccola e dall'albero. Fai attenzione a che il cavo non si riattacchi. La boccola potrebbe rimanere nella parte superiore o sull'albero. Se è sull'albero, rimuovila e mettila da parte.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0