crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

iPhone 5前面板与显示屏替换

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935421:0crwdne2935421:0

crwdns2935425:06crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:06crwdne2931653:0
iPhone 5 LCD and Digitizer Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

  • The bare display assembly remains.

  • For reassembly, make sure to transfer over the LCD shield, home button, front facing camera assembly, front facing camera lens bezel and earpiece speaker to your new part.

  • If the replacement screen seems to not fit in the original frame, do not put too much force on the screen, or the glass might crack. Instead, try inserting the screen at a 30° angle, starting at the top. The aim here is to get the three plastic brackets under the metal frame of the phone and move with slight pressure from the sides to the bottom.

  • Make sure to remove the protective cover from your new display assembly as well as the protective cover on the back of the LCD.

  • Note: When reassembled, the screen may not turn on. Try fixing this by plugging your phone in, and holding down the power and home buttons at the same time for 20 seconds.

剩下的就是裸露的显示模组。

重新组装时，确保显示屏挡板、Home键、前摄像头及其镜头挡板、以及耳机扬声器已经转移到新的前面板上。

当您安装新的屏幕时发现无法完全安装至机身中时，请不要过于用力在屏幕上，否则可能导致屏幕碎裂。相反的，尝试将屏幕以30°角从上至下插入安装。目标就是将三个塑料挡片插入手机中框中，然后轻轻向下滑动到位固定

确保移除了新的显示模组背面及正面的保护膜。

注意：重新组装后，显示屏可能无法点亮。尝试将iPhone插好充电线，然后同时按住电源键和Home键20秒以上。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0