crwdns2935425:01crwdne2935425:0
crwdns2931653:01crwdne2931653:0
-
Remove the following screws securing the Lightning connector assembly to the rear case:
-
One 2.9 mm Phillips screw
-
One 1.5 mm Phillips screw
-
Two 3.3 mm Phillips screws
| - | [* black] Gently peel the speaker assembly away from the Lightning connector ribbon cable. |
|---|---|
| - | [* icon_note] If you are replacing the Lightning connector with a new part, make sure to transfer the rubber casing around the microphone. You can do this using a spudger. |
| + | [* black] Remove the following screws securing the Lightning connector assembly to the rear case: |
| + | [* red] One 2.9 mm Phillips screw |
| + | [* icon_reminder] During re-installation, make sure that the headphone jack's plastic protrusion lies above the metal washer. |
| + | [* orange] One 1.5 mm Phillips screw |
| + | [* yellow] Two 3.3 mm Phillips screws |
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0