How to stop "BEEP" sound by removing the Internal Speaker.

crwdns2935425:06crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:06crwdne2931653:0

Reassembling the Heater - Part I

It's time to test our work. Before fully reassembling the Heater.
STEP 1 - Plug the cables back in carefully.
STEP 2 - with the Heater standing upright, position the Circuit Board upright as well; if you have to adjust the cable so it will stay do so, or even tape it temporarily works to.
Be Advised if the Circuit Board is not upright you will get a blinking green decimal on the panel. This means that the trip sensor is activated since the sensor is in this Circuit Board.
Once everything is in place, plug the heater in, which should have been near a circuit before starting.
You should hear a click sound which is the thermostat, and then no more beeps! Try out your panel buttons they should all work and be silent.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0