crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Remplacement de la batterie du Huawei P10 Plus

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:01crwdne2931653:0
Huawei P10 Plus Battery Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Huawei P10 Plus Battery Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Huawei P10 Plus Battery Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • There is a stretch-release adhesive tab between the battery and the motherboard, use tweezers to pull them from the gap before you begin pulling.

  • Peel out the adhesive strip by steadily pulling at the tab in a flat angle.

  • If the adhesive strip breaks, you can grab and twist it around a tweezers tip a couple of times and continue to pull.

  • Follow the heating instructions and place an iOpener over the battery to soften the remaining adhesive strip.

Une bande adhésive étirable d'extraction se trouve entre la batterie et la carte mère. Prenez une pincette pour la sortir de son emplacement avant de commencer à tirer.

Décollez la bande adhésive en tirant constamment sur la languette et en formant un angle proche de l'horizontale.

Si la bande adhésive se déchire, vous pouvez la saisir et l'enrouler plusieurs autour de la pointe d'une pincette, puis continuer à tirer.

Suivez les instructions de chauffage et posez l'iOpener sur la batterie pour ramollir la bande adhésive restante.

-[* black] There is a stretch-release adhesive tab between the battery and the motherboard, use tweezers to pull them from the gap before you begin pulling.
+[* black] There is a stretch-release adhesive tab between the battery and the motherboard, use [product|IF145-020|tweezers] to pull them from the gap before you begin pulling.
[* black] Peel out the adhesive strip by steadily pulling at the tab in a flat angle.
[* icon_note] If the adhesive strip breaks, you can grab and twist it around a tweezers tip a couple of times and continue to pull.
[* black] [guide|11677|Follow the heating instructions|new_window=true] and place an iOpener over the battery to soften the remaining adhesive strip.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0