crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Remplacement du condensateur du flash du Canon EOS Rebel T6i

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:01crwdne2931653:0
Canon EOS Rebel T6i PCB Flashboard Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

  • Caution: Failure to follow these steps may lead to damage or injury from electrical shock. Before removing or touching the PCB board, the capacitor needs to be checked for voltage. This device is the black cylinder on the camera.

  • Place a voltmeter in parallel with the capacitor. If a charge is detected, make sure the battery is removed from the device.

  • The positive pin is connected to the positive terminal and negative to the negative terminal. Switch the setting of the multimeter to ADC for direct current amperage.

Avertissement - Avant de retirer ou de toucher la carte PCB, la tension du condensateur doit être vérifiée. Cet appareil est le cylindre noir de l'appareil photo. Placez un voltmètre en parallèle avec le condensateur. Si une charge est détectée, assurez-vous que la batterie est retirée de l'appareil.

De plus, la broche positive est connectée à la borne positive et négative à la borne négative. Basculez ensuite le réglage du multimètre sur ADC pour l'ampérage en courant continu. .

-[* black] Warning - Failure to follow steps may lead in damage or injury from electrical shock. Before removing or touching the PCB board, the Capacitor needs to be checked for voltage. This device is the black cylinder on the camera. Place a voltmeter in parallel with the capacitor. If a charge is detected, make sure battery is removed from the device.
-[* black] Furthermore, The positive pin is connected to the positive terminal and negative to the negative terminal. Then switch the setting of the multi meter to ADC for direct current amperage. .
+[* icon_caution] Caution: Failure to follow these steps may lead to damage or injury from electrical shock. Before removing or touching the PCB board, the capacitor needs to be checked for voltage. This device is the black cylinder on the camera.
+[* black] Place a voltmeter in parallel with the capacitor. If a charge is detected, make sure the battery is removed from the device.
+[* icon_note] The positive pin is connected to the positive terminal and negative to the negative terminal. Switch the setting of the multimeter to ADC for direct current amperage.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0