Presidential 2.0 Roller Arm Replacement

crwdns2935425:09crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936325:0crwdne2936325:0

crwdns2931653:09crwdne2931653:0

remove nut using a wrench . There should also be a small washer but they usually get stuck inside , they should fall out during the next step.
Next this bolt will need to be tapped out . you can either LIGHTLY tap it with a wrench from the threaded end ( see last step) or you can use vice grips .
Once Bolt is removed the arm is now loose . It may require some hand force to detach it from the assembly .
Beware if you are working on the right side roller arm ( sitting position) there will be an extra sensor that needs to be unplugged

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0