crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

HP Stream 13-c002dx Vervanging van het toetsenbord

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:04crwdnd2931529:0crwdne2931529:0

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:01crwdne2931653:0
HP Stream 13-c002dx Keyboard Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 HP Stream 13-c002dx Keyboard Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

  • Begin by placing your laptop on a clean surface such as a table and away from any liquids which may spill and damage components.

  • Flip the laptop over so the bottom is facing up.

  • Use your Phillips #0 screwdriver to remove the eleven visible 5 mm screws on the back of the laptop.

  • There are some screws underneath the rubber feet. Use a spudger to remove them and gain access.

  • Unscrew the two remaining 2.5mm screws. Keep these screws separate from the first eleven 5mm screws.

Zet je laptop allereerst op een vlak en gelijk oppervlak zoals een tafel. Zorg dat je niet werkt in de buurt van vloeistoffen die mogelijk je laptop kunnen beschadigen.

Draai de laptop zo om dat de onderkant naar boven wijst en gebruik dan je Phillips #0 schroevendraaier om de 11 zichtbare 5 mm lange schroefjes aan de achterkant te verwijderen.

Er bevindt zich een aantal schroefjes onder de rubberen voetjes. Verwijder deze rubbertjes om toegang te krijgen tot de schroefjes.

Schroef de twee overgebleven 2.5 mm lange schroefjes los. Houd deze schroeven apart van de eerste elf 5 mm lange schroeven.

-[* black] Begin by placing your laptop on a clean surface such as a table and away from any liquids which may spill and damage components.
-[* red] Flip the laptop over so the bottom is facing up and use your Phillips #0 screwdriver to remove the 11 visible 5mm screws on the back.
- [* icon_note] There are some screws underneath the rubber feet. Remove them to gain access
+[* icon_note] Begin by placing your laptop on a clean surface such as a table and away from any liquids which may spill and damage components.
+[* black] Flip the laptop over so the bottom is facing up.
+[* red] Use your Phillips #0 screwdriver to remove the eleven visible 5 mm screws on the back of the laptop.
+ [* icon_note] There are some screws underneath the rubber feet. Use a spudger to remove them and gain access.
[* orange] Unscrew the two remaining 2.5mm screws. Keep these screws separate from the first eleven 5mm screws.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0