iPhone 8的Home键/Touch ID传感器的更换

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:05crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:01crwdne2931653:0

Remove the home/Touch ID sensor bracket

Remove the four Y000 screws securing the bracket over the home/Touch ID sensor:
One 1.2 mm screw
Remove this screw first. Excess pressure may bend the home button bracket if you remove the 1.3mm screws first.
Three 1.3 mm screws
Remove the bracket.
During reassembly, be careful not to overtighten these screws, or your home button may not work.

移除主屏幕按钮/Touch ID传感器支架

移除 home键/Touch ID传感器 后的支架上的四个Y型螺丝。
一个1.2mm螺丝
请先拧下这颗螺丝。如果先拧下1.3 mm的螺丝，可能会因压力过大而使手机顶部的按键支架变形。
三个1.3mm螺丝
移除支架。
重新组装时，请注意不要拧得太紧，否则Home 键可能不起作用。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0