crwdns2915892:0crwdne2915892:0
You should firstly follow the first guide on how to open the device before proceeding to this guide.
Pay attention to the precautions mentioned in the guide.
crwdns2942213:0crwdne2942213:0
-
-
First ensure your laptop is turned off and check if you have the necessary tools
-
-
-
All screws are identified by circles. Pay special attention to the yellow circles, as the rubber feet hide screws.
-
-
-
With the opening tool, remove a rubber foot.
-
For this action you will have to exert some force, because the foot is glued with a resistant glue.
-
-
-
Remove all screws with a Philips screwdriver PH1
-
All screws are the same so don't worry about identifying them.
-
-
-
-
With the plastic tool, insert between the plastics and gently pry open.
-
With your fingers continue to force open the bottom cover on the side indicated in the figure.
-
You will feel and hear several clicks, perfectly normal, nothing is breaking. Remove the cover completely.
-
-
-
Finally, we have the laptop open and ready to replace most of its components. Look elsewhere on how to replace a component.
-
To close the laptop just follow this guide in reverse.
-
-
-
Remove mylers shown in the picture.
-
Save them for the battery assembly steps.
-
-
-
Disconnect the cable marked in the figure gently, pulling it out of the connector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
