Texas Instruments TI-83 Plus IO Port Replacement

crwdns2936079:0crwdne2936079:0

crwdns2935359:0crwdne2935359:0

crwdns2935357:0crwdne2935357:0

crwdns2935361:0crwdne2935361:0

crwdns2935365:0crwdne2935365:0

crwdns2943215:0crwdne2943215:0

1 × T6 Torx Screwdriver
1 × Soldering Iron—Anything 60W or higher is preferrable.
1 × Spudger—Optional but highly preferrable
1 × Epoxy, 15ml—Only required if using a generic headphone jack instead of an official one
1 × Lead-Free Solder, Lead-Free, 0.8mm diameter—Leaded will also work
1 × Phillips #0 Screwdriver

crwdns2943213:0crwdne2943213:0

1 × TI83+ Replacement IO Port, 2.5mm SMD—Instead of this you may also use a generic 2.5mm or 3.5mm 3-Pole Female SMD Headphone Jack.
2 × Resistor, Pin Through Hole—Value does NOT matter! Only required if using a generic headphone jack instead of an official one

crwdns2915888:0crwdne2915888:0

crwdns2935375:0crwdne2935375:0 crwdns2915442:0crwdne2915442:0

crwdns2918526:0crwdne2918526:0

crwdns2935377:0crwdne2935377:0

crwdns2935379:0crwdne2935379:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0