Making a low cost photography light stand

crwdns2936079:0crwdne2936079:0

crwdns2935359:0crwdne2935359:0

crwdns2935357:0crwdne2935357:0

crwdns2935361:0crwdne2935361:0

crwdns2935365:0crwdne2935365:0

crwdns2943215:0crwdne2943215:0

1 × 6-in-1 Screwdriver—Phillips #2 bit commonly used.
1 × Flush Cutter—Only needed to remove press fit bulb sockets. This will allow for a clean cut to make cord reuse easy.
1 × Broken lamp

crwdns2943213:0crwdne2943213:0

1 × Clamp light—Buy this locally when possible to mitigate shipping damage.
1 × BR40 LED lightbulb — medium base, 5000-5500k recommended—100W 1,500+ lumens recommend. Make sure to use 5000-6500k bulbs (90+ CRI recommended).
1 × Workshop LED — medium base—Provides more working light but may result in poor exposure on cameras with poor light metering. Use of a DSLR or Mirrorless camera is advised, unless you are prepared to fix this in post processing.

crwdns2915888:0crwdne2915888:0

crwdns2935375:0crwdne2935375:0 crwdns2915442:0crwdne2915442:0

crwdns2918526:0crwdne2918526:0

crwdns2935377:0crwdne2935377:0

crwdns2935379:0crwdne2935379:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0