crwdns2915892:0crwdne2915892:0
If the iRobot Looj 120 has stopped working and all the motors are okay and the battery is charged, then there may be a problem with the circuit board within the handle. This guide will show you how to replace the circuitry in the remote handle.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four exterior screws located under controller and on the handle.
-
Remove the five screws shown, and then carefully remove top plate. Electrical components are attached to top plate.
-
-
-
-
Disconnect circuit board from power leads, and install new circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team 2-5, Duarte Fall 2014 crwdns2935289:0UMass Dartmouth, Team 2-5, Duarte Fall 2014crwdne2935289:0
UMASSD-DUARTE-F14S2G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Where can you get the replacement circuit board for the remote control?
