crwdns2915892:0crwdne2915892:0
Prerequisite for entire button ribbon cable, volume buttons, power button, and rear case.
crwdns2942213:0crwdne2942213:0
-
-
Insert the flat end of a spudger between the rear-facing camera and its frame.
-
Gently twist the spudger to free the camera.
-
Lift the rear-facing camera up out of its socket, and remove it from the iPod Touch.
-
-
-
Gently slide the flat end of a spudger underneath the piece of foam tape covering the button ribbon cable.
-
Run the spudger along the full length of the tape to disconnect it from the rear case.
-
-
-
-
Peel and remove the foam tape from the rear case of the iPod.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use the tip of a spudger to peel up the edge of the tape covering the button ribbon cable.
-
Use tweezers or your fingers to peel the tape up from the rear case, and remove it from the iPod.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
