iPod Touch 4th Generation Upper Logic Board Replacement

crwdns2931653:01crwdne2931653:0 Upper Logic Board

• Remove the following three screws near the top edge of the logic board:
• One 2.0 mm Phillips screw
• Two 2.3 mm Phillips screws
crwdns2913378:0crwdne2913378:0
crwdns2935263:04crwdne2935263:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:02crwdne2931653:0

• Use the edge of an iPod opening tool to gently pry, but not remove, the rear-facing camera away from the rear case.
• Do not attempt to remove the rear-facing camera yet.
crwdns2913378:0crwdne2913378:0
crwdns2935263:02crwdne2935263:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:03crwdne2931653:0
• Use an iPod opening tool to slightly lift the edge of the logic board next to the battery enough to grab it with your other hand.
• Do not excessively bend the logic board, as it is very thin and fragile.
• Be very careful not to lift too much as the volume control ribbon cable is still connected and will tear very easily.
• While gently lifting the logic board with one hand, use an iPod opening tool to lift the logic board near the copper tape at the logic board's top edge.
• The logic board will be lifted adequately when the last display assembly connector has cleared the top edge of the rear case.
crwdns2913378:0crwdne2913378:0
crwdns2935263:07crwdne2935263:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2862417:0crwdne2862417:0

crwdns2935293:0crwdnd2935293:08crwdnd2935293:0crwdne2935293:0

Walter Galan

694,561 crwdns2915208:0crwdne2915208:0

crwdns2935297:01,203crwdne2935297:0

crwdns2918514:0crwdne2918514:0: 54

• 
• 
• 

crwdns2935301:051crwdne2935301:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

crwdns2852917:0crwdne2852917:0