crwdns2915892:0crwdne2915892:0
Remove the logic board and battery as one unit.
crwdns2942213:0crwdne2942213:0
-
-
Before proceeding, be sure your Shuffle is switched off.
-
-
-
Use a combination of iPod opening tools and metal spudgers to pry the rear panel away from the Shuffle by the seam nearest the ON/OFF switch.
-
-
-
Remove the rear panel from the Shuffle.
-
-
-
-
Remove the single 2.1 mm Phillips screw securing the logic board to the front case.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use the edge of an iPod opening tool to flip up the retaining flap on the control button cable ZIF socket.
-
Use a pair of tweezers to gently pull the control button ribbon cable out of its socket.
-
-
-
Use an iPod opening tool to gently pry the battery off the adhesive securing it to the front case.
-
Lift the battery out of the front case, being sure not to strain its delicate leads.
-
-
-
Insert the tip of a metal probe into the hole molded into the logic board retainer nearest the logic board.
-
Pry the retainer first away from the front of the front case, then pull it away from the side of the front case.
-
Remove the logic board retainer from the Shuffle.
-
-
-
Use the edge of an iPod opening tool to push the headphone jack down toward the center of the Shuffle.
-
-
-
Continue pushing the logic board down away from the top edge of the Shuffle.
-
Pull the logic board out of the front case by the side nearest the ON/OFF button and gently maneuver the headphone jack out of its recess in the front case.
-
Remove the logic board assembly from the Shuffle.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:014crwdne2935229:0
