iPod Shuffle 3rd Generation Logic Board Replacement
crwdns2944107:0crwdnd2944107:0Matthew Newsomcrwdnd2944107:0crwdnd2944107:0crwdnd2944107:04crwdnd2944107:0crwdne2944107:0
crwdns2944111:0August 15, 2022crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0Replace that faulty logic board to restore functionality to a broken iPod Shuffle.
crwdns2942213:0crwdne2942213:0
crwdns2943215:0crwdne2943215:0
crwdns2944105:0crwdne2944105:0
-
-
Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.
-
-
-
Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.
-
-
-
Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.
-
Pry the rear case away from the front case.
-
-
-
Lift the bottom of the rear case and remove it from the rest of the iPod.
-
-
-
Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.
-
-
-
Remove the single Phillips screw securing the logic board to the front case.
-
-
-
Peel the battery up from the front case with an iPod opening tool.
-
Remove the logic board and battery from the iPod.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
