crwdns2942213:0crwdne2942213:0
-
-
Remove the four screws securing the upper connector cover:
-
Two 1.4 mm-long Phillips screws
-
One 3.5 mm-long Phillips screw
-
One 1.0 mm-long tri-point Y000 screw
-
-
-
Use tweezers or your fingers to remove the upper connector cover.
-
-
-
Use the point of a spudger to disconnect the power/Camera Control button press connector.
-
-
-
-
Disconnect the two rear camera press connectors, located underneath and to the left of the power/Camera Control button connector.
-
-
-
Use your Phillips screwdriver to remove the three screws securing the rear cameras:
-
One 3.2 mm‑long screw
-
One 4.7 mm‑long screw
-
One 2.4 mm‑long screw
-
-
-
Use a spudger or clean fingertip to pry up the top edge of the rear cameras until you can grab them with your fingers.
-
-
-
Lift the cameras straight up, then pull them towards the top of the phone to remove them.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
