crwdns2915892:0crwdne2915892:0
Prereq only.
crwdns2942213:0crwdne2942213:0
-
-
Use a plastic opening tool to gently fold the front-facing camera cable upwards (roughly at a 90-degree angle), exposing the bottom side of it.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use a set of tweezers to peel up the small piece of tape covering the microphone cable connector.
-
-
-
Use the tip of a spudger to gently lift the tab on the microphone ribbon cable's ZIF connector.
-
-
-
-
Slide the tip of a tweezer under the microphone cable to separate it from the adhesive holding it to the headphone jack cable.
-
-
-
Use tweezers to pull the microphone cable straight out from its ZIF socket.
-
Gently bend the microphone cable up and out of the way of the headphone jack cable.
-
-
-
Remove any tape covering the headphone jack cable connector.
-
-
-
Use a plastic opening tool to fold the headphone jack cable clips outward, away from the cable, freeing the cable connector.
-
-
-
Use a plastic opening tool to pry the headphone jack cable's connector up from its socket on the logic board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
