crwdns2915892:0crwdne2915892:0
Internal prereq.
crwdns2942213:0crwdne2942213:0
-
-
Carefully move, but do not remove the front-facing camera ribbon cable aside with the flat edge of a spudger.
-
-
-
Peel back and remove the adhesive tape covering the headphone jack assembly.
-
-
-
Using the tip of the spudger, flip up the retaining flap on the microphone cable ZIF connector.
-
-
-
-
Insert the tip of the spudger underneath the microphone ribbon cable and carefully push it out from its socket on the ZIF connector.
-
Use the flat edge of a spudger to move the microphone ribbon cable aside.
-
-
-
Flip up the retaining flap securing the volume/power button ribbon cable connector to the headphone jack assembly board.
-
-
-
Push the volume button ribbon cable from its ZIF connector.
-
Gently bend the volume button ribbon cable upwards to move it aside.
-
-
-
Remove the following screws from the headphone jack assembly:
-
Five 2.6 mm Phillips #0
-
Two 2.2 mm Wide Head Phillips #00
-
Two 2.6 mm Phillips #00
-
-
-
Holding onto the ribbon cable of the headphone jack assembly, carefully pull the assembly upwards towards the top of the device.
-
-
-
Grasping the headphone jack assembly with one hand, pull the assembly from the iPad, minding any cables that may get caught.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.