crwdns2915892:0crwdne2915892:0
Internal Prereq.
crwdns2942213:0crwdne2942213:0
-
-
Pull the hard drive temperature sensor connector toward the top edge of the iMac to disconnect it from its socket on the logic board.
-
-
-
Remove the two 9 mm T10 Torx screws securing the upper hard drive bracket to the outer case.
-
-
-
-
Slightly rotate the hard drive out of the outer case and lift it up off its mounting pins toward the top edge of the iMac.
-
-
-
Disconnect the SATA data cable and SATA power connector from their respective sockets by pulling each connector away from the hard drive.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.